Today, we’re going to put together the pieces we created yesterday for the seat cushion.

If you are using piping, baste your piping around the edges on the right side of one of the surface area pieces. Do the same for the other piece.



Overlap the ends of your piping and let them go off the edge.



Pin your side strip in place with the zipper in the back.



I start sewing here going in the direction I’m pointing. (I will show you why in a minute.)



It will look like this once sewn in place.



Here’s what always happens to me and why I started where I did. I have a little extra. I am completely comfortable with just folding it over and keeping on keeping on. When the cushion is on your chair, you can’t see it because of where it is placed!



Unzip your zipper slightly and sew the other side of your strip to your other surface piece.



Finish unzipping your zipper and turn your cushion cover right side out. Stuff your cushion into it.



Here’s the flaw where I folded it over.



Your finished slipcover! (Note to self: You should iron it before you take pictures.)



Post pictures when you are done! I’m dying to see it 