PDA

View Full Version : Quilted Insulated Casserole Carrier Tutorial - DL



SGRAHA
10-29-2010, 05:09 PM
This carrier will hold most round/oval casserole dishes and the smaller square dishes. I put my very large 3 quart round in it with no problems as well as my 2 quart oval.

Materials needed -
Cotton woven print for outer & straps, minimum 7/8 yd.
Cotton woven coordinate for inner, minimum of 5/8 yd.
Insulbrite insulating batting - minimum 5/8 yd.
2 D-rings, i use 1 1/2" here

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute1.jpg
Step 1
Cut the following pieces -
From print - 24" square
one 4" wide x 44" long strip
From coordinate - 21" square
From insulbrite - 21" square

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute2.jpg
Step 2 - on a large work table lay the print 24" square wrong side up, center the insulbrite & lining fabric (right side up).

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute3.jpg
Step 3 - Pin in several places to hold layers together. Alternately you could use basting stitches or spray.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute4.jpg
Step 4 - Mark quilting lines with chalk marker/pencil. I just use a grid pattern but you could do whatever type of quilting you like.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute5.jpg
Step 5 - Quilt. For the grid i start at the middle and work my way out to the sides, it's easier to keep it from bunching and shifting this way.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute6.jpg
Step 6 - Trim up the lining and insulbright so they are even. Leave the print fabric to extend 1 1/2" beyond the other fabrics on all four sides.

Step 7 - *sorry i didn't get a picture for some reason* Fold raw edge of the print fabric even with the edge of the other layers and iron down to create the binding for the edge. Pin if needed to hold in place.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute7.jpg
Step 8 - Use a marking pen to mark 1 1/2" from each corner of the binding.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute8.jpg
Step 9 - Take a piece of tape and lay diagonally corner to corner matching up with the marks you made in Step 8.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute9.jpg
Step 10 - Fold the corner w/ print sides facing, aligning folded fabric edges.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute10.jpg
Step 11 - Sew down right side edge of tape (i go forward and then backstitch to make sure it's stable).

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute11.jpg
Step 12 - Trim to 1/4" from stitching/tape edge. Remove tape. This creates a perfectly mitered corner.

REPEAT for all 4 corners.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute12.jpg
Step 13 - Flip all 4 corners over.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute13.jpg
Step 14 - Iron binding down all the way around giving a bit of steam to corners if needed to get it to lay totally flat. Pin in place if necessary.
SEW binding in place all around.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute14.jpg
Step 15 - Iron 4" wide strip in 1/2 and then fold in each side to middle and iron down.
http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute15.jpg
Fold in 1/2 again and iron/steam as needed.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute16.jpg
Step 16 - Sew 1/4" from folded edge. I sew an additional 2 lines of stitching down strap to make it more sturdy.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute17.jpg
Step 17 - Cut the 44" long strip into the following pieces -
2 - 3 1/2" long pieces
1 - 27" long piece

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute18.jpg
Step 18 - Turn under 1/2" on both narrow ends of long strap. Pin diagonally corner to corner of inside of carrier.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute19.jpg
Step 19 - Sew each end down securely. I sew a box at each end and then an X through the box to make sure it's very secure for carrying.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute20.jpg
Step 20 - Put the D Ring through each of the smaller loops. Fold in half and turn raw edge under 1/2" and stitch in place securely as above.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute21.jpg
This is what it should look like laid out flat when you are done.

http://i4.photobucket.com/albums/y109/SarahBethGraham/casseroletute22.jpg
Casserole carrier gets centered under the long strap and you put the strap through each D ring and pull up over the dish :-)

ENJOY!

jcsews
10-29-2010, 05:56 PM
Love it! I have never seen a carrier like this before. It looks great!

Chrisnkelley
10-29-2010, 05:58 PM
That's really cool!! I was just thinking I need a few new casserole carriers today and was trying to figure out a pattern. maybe I'll just try yours out! Thanks :)

SGRAHA
10-29-2010, 06:09 PM
The pattern originally was in a magazine, country women maybe? not sure but someone cut it out and saved it. I've made a few of them. My favorite part is the mitered corners, works awesome for placemats and quilts too :-)

northernmama
10-29-2010, 06:23 PM
awesome tute! good for the holidays and potluck! TFS

anacris
10-29-2010, 08:06 PM
Love it! Thank you :)

plainjanesews
10-29-2010, 08:11 PM
love that! thanks for the great tute. i will try this one... i am confused on how the strap works.. you put the dish under the long strap and then pull the straps through the rings?

suprneko
10-29-2010, 08:11 PM
Very nice tute! You take good closeup pics, too!

SGRAHA
10-30-2010, 06:02 AM
love that! thanks for the great tute. i will try this one... i am confused on how the strap works.. you put the dish under the long strap and then pull the straps through the rings?

Yes here's some pictures of another one i did that shows it with the dish -
http://i4.photobucket.com/albums/y109/SarahBethGraham/SEWsationalSarah/casserolecarrier2-1.jpg
http://i4.photobucket.com/albums/y109/SarahBethGraham/SEWsationalSarah/casserolecarrier3-1.jpg
http://i4.photobucket.com/albums/y109/SarahBethGraham/SEWsationalSarah/casserolecarrier1-1.jpg

Does that make it easier to understand?

plainjanesews
10-30-2010, 08:37 AM
thanks! that totally makes sense now! thanks for the extra pics.. i bet you could add those to the original tute and get a couple more points- hehehe those are going on my teacher gift list~ and my new mom gift list. how great would that be with a casserole in it for a new mom?

thefabrickat
10-30-2010, 09:55 AM
wow, thanks so much for sharing (and I was wondering about the strap too <g>)

ericaeli
01-05-2011, 10:52 AM
I just wanted to say thanks for this tutorial! I made several for Christmas, and everyone loved them. I even had to show my mother how to make them because she wants to make them for everyone! They make the perfect hostess gift. I made matching cloth grocery bags to go with them.

SGRAHA
01-05-2011, 03:56 PM
Thanks for letting me know Erica :-) I'm making several this year for craft fairs i think they'll be popular :-)